Chase Research IOPRINT+ Print Server Guide de l'utilisateur télécharger pdf (Page 269)

IOPRINT+ Print Servers

Using FTP

Page 269

Commands

Only the following commands are implemented. Commands are usually case sensitive.

Where the command requires a parameter, the parameter is shown in italics.

dir - List files (as shown in the previous table).

get FILENAME - Retrieve a file. The only files that can be retrieved are CONFIG and

PSINF. Using GET with the other "files" will activate a command, as follows:

put CONFIG - Copy the file CONFIG to the device, overwriting the existing CONFIG file.

Details of the format of CONFIG files are contained in Appendix B - Configuration File

Format.

put PASSWORD - Copy the file PASSWORD to the IOPRINT+ Print Server, giving it a

new password. Passwords can be up to 19 bytes in length.

put filename Ln - Copy the file filename to the printer connected to Logical Port n, where

n is a Logical Port number. This will print the file.

quit - Terminate the current FTP session.

Other FTP Commands - The other FTP commands are not implemented, and will usually

return the error message Invalid command.

Item Description

get DEFAULTC Set the IOPRINT+ Print Server back to its default

configuration.

get RESET Reset the IOPRINT+ Print Server. This also

terminates the current connection.

get PASSRESET Clear password (no password).

get SETIP Set the current IP address as a static IP address.

Warning

Do NOT use the SETIP command if the device has an IP

Address assigned by a DHCP server. This will cause an

Address conflict

Note

After using the put CONFIG command to write a new configuration file to the device,

you should issue a get RESET command.

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 304 305

Pas de commentaire

Chase Research IOPRINT+ Print Server Guide de l'utilisateur Page 269