Chase Research IOPRINT+ Print Server Guide de l'utilisateur télécharger pdf (Page 267)

IOPRINT+ Print Servers

Introduction

Page 267

Introduction

FTP (File Transfer Protocol) allows a user to log-on to a remote host, and manipulate files on

the host. The IOPRINT+ Print Server can act as a FTP host, allowing FTP to be used for both

configuration and printing. However, the following limitations apply:

• Only one FTP user can connect to the IOPRINT+ Print Server.

• Only "command line" FTP programs can be used. FTP programs which attempt to

"browse" the file system are NOT supported.

Using FTP

1. Configure the IOPRINT+ Print Server so that it has a valid IP Address.

2. Start your FTP client from the command prompt (GUI interface FTP clients are NOT

supported) and connect to the IOPRINT+ Print Server using its IP Address.

e.g. ftp 203.70.212.155

3. The IOPRINT+ Print Server will respond with "Print Server Ready" and prompt for

"Name", as shown below:

4. Enter the name for this device. If you have not assigned a name, you must use the

"Default name" shown on the sticker on the base of the unit. The "Default name" is in the

form SCxxxxxx (SC followed by 6 digits).

5. You will then be prompted for the password. If no password has been set, just press

ENTER.

6. From the resulting prompt, you can manipulate the following files, and use the following

commands.

Connected to 203.70.212.45

#220 Print Server Ready

Name (203.70.212.45:root):

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 304 305

Pas de commentaire

Chase Research IOPRINT+ Print Server Guide de l'utilisateur Page 267